Ultima 5 Digital TENS Unit With Timer - U5

 

 

 

 

 

 

 

 

Product Description

Ultima 5 Digital TENS Unit With Timer. Transcutaneous Electrical Nerve Stimulation (T.E.N.S.) systems, also known as TENS Units, are designed to relieve both acute and persistent pain without shots, drugs or narcotics. They send gentle electrical impulses through the skin to the nerves to suppress pain by scrambling the pain signals before they reach the brain. A "TENS unit" is a pocket size, portable, battery-operated device that sends electrical impulses to certain parts of the body to block pain signals. The electrical currents produced are mild, but can prevent pain messages from being transmitted to the brain and may raise the level of endorphins (natural pain killers produced by the brain).

Ultima 5 Digital T.E.N.S. Unit Specifications

Channel: Dual

Output: Maximum 130 mA (peak value) across 500 Ohm load

Pulse Width: 50 μS to 250 μS adjustable

Pulse Rate: 1 Hz to 150 Hz adjustable

Wave Form:
1. Symmetrical Bi-phasic rectangular
2. Mono-phasic rectangular

Mode: 5 Modes are available:
- Mode A – Constant
- Mode B – Burst I - Two train per second, 250ms on, 250ms off; 25 pulses within one train, pulse width=200μS
- Mode C – Burst II - Two train per second, 250ms on, 250ms off; Pulse width & frequency are selectable
- Mode D – Pulse width modulation - Pulse width modulated from 100μS to 250μS within 6 seconds & then back to 100μS in the next 6 seconds. Pulse rate is selectable,
- Mode E – Pulse rate and Pulse width Modulation - Frequency increase from 50Hz to 100Hz while pulse width decrease from 200μS to 60μS within 5 seconds.

Treatment Timer: Continuous, 15min, 30min, 45min, 60min selectable

Operation:
1. When mode changes, the intensity will automatically go down to zero
2. When the unit is turned on, it will automatically enter the mode that the unit had worked in before the unit was turned off 3. When the pulse rate, pulse width or intensity is being adjusted, the auto-repeat function is available, when the key is held down over 1 second, it will automatically increased/decreased 1 step per 1/4 second 4. When the batteries are low, the symbol of battery is flashing in 2 Hz indicating that the batteries should be replaced 5. Automatic shut off: When the unit intensity levels are 0 on both channels, and it has not been in use for 5 minutes, the unit will be shut off automatically.

Included:

Unit with display 52.5 mm X 35.8 mm LCD

2 AA batteries

One pack of high quality electrodes

Set of lead wires

Manual

Carrying Case - Soft compact carrying case

Note: This unit is a Class II Medical Device and by FDA regulations cannot be returned if it has been used. 

If you would like to purchase this item click here.